Product Review Taken From Four Small Wheels Magazine The way in which this kit has been planned and executed is a little unusual but makes sense the more we look at it. Under the skin itís not the highest detail kit that weíve seen and should be quite a simple assembly job with the top of an engine moulded into the deck on the back of the cockpit tub, decent wheels and brakes, a fine roll cage and a few other separate interior parts such as the seat, dashboard and gear shift controls. The car has a full undertray, so thereís little in the way of suspension but itís the body that is the most interesting aspect. The door and lower rear side panel are moulded as one and fit into the body with an additional central vein that has the radiators mounted to it before installation. Itís all a lot more straightforward than it perhaps sounds and whether you use the kit decal for the press car or one of the Studio 27 sheets recently released, youíll have a good looking model and something different.
Mass produced plastic kits that build well. Instructions usually in several languages. Some subjects require slightly more advanced modelling techniques but these are well explained in the instructions. Made in Japan.
McLaren MP4-12C GT3 model by Fujimi
Plastic Kit: 1:24
Also available STUFP24154 etched detailing set.
Grand Prix Models, your number one choice forFujimi - McLaren MP4-12C GT3 model